Cleaning your Esprecious coffee machine on a regular basis helps to keep it in tip top condition. London Coffee Machines animated cleaning guide will guide you through the process step by step.
Need help with your Esprecious Machine call 0208 111 1122 or email us
Cleaning your Esprecious Coffee Machine
Need some help? our in-house team of technicians are on hand to solve any problems that you may have with your Esprecious Coffee Machine, or any of our other other rental or Lease coffee machines.
Our typical response time to fault calls is less than one working day.
Steps to Cleaning your Esprecious Coffee Machine:
FLUSH MIXING BOWL CYCLE = DAILY DEPENDING ON VOLUME
In order to maintain a correct operation of the machine the mixing bowl unit should be flushed each day.
On the front of the coffee machine, select the button on the digital display above the drinks options in the top right (1), press the maintenance menu button for more options. Again in the top right press the ‘flush brewer and mixer’ option on the display.
Careful! Hot water comes out from the beverage unit so place a container under the drinks nozzle (2) to collect the hot water.
GROUT BIN = DAILY DEPENDING ON VOLUME
The grout bin collects all the coffee grounds and should be emptied every day depending on volume.
Remove the grout bin using the handle available (left hand side) for pulling the grout bin out, then empty and clean.
Make sure the waste bin is completely dry, and then replace.
On the front of the machine Answer the message on screen with YES the waste bin will be set back to 0.
DRIP TRAY = DAILY DEPENDING ON VOLUME
The drip tray located at the front base of the Coffee machine needs to be emptied and/or cleaned.
To remove the drip tray hold the tray and slide the drip tray forward.
Once the tray is clear of the machine remove the drip tray grid (the top just pulls off).
Empty and clean the drip tray, and grid. Before replacing the grid check the ‘red float’ is still in place, if so replace the grid and slide the drip tray back into the machine.
Its best to empty the drip tray daily, when full a warning is displayed on the machine panel and removing the tray is more difficult as its likely to spill.
BEVERAGE OUTLET = WEEKLY DEPENDING ON VOLUME
To remove and clean the beverage outlet, Turn the key (half way up on the left hand side) on the coffee machine to open coffee machine door. Open the panel fully to access the components.
First remove the two hoses (1) from the brewer and the mixing bowl (brown hose from the brewer on the left, and black hose from the mixing bowl on the right hand side of the machine). Also make sure the grout bin has also been removed from the machine.
Once the hoses and grout bin are removed, hold the beverage outlet and slide to the left (2) to disengage from the machine.
The beverage outlet splits into two Squeezing each side of the arm (1) and the pieces will rotate down (2) to separate.
Once all the parts are removed clean dry and install in the reverse order making sure the black and brown hoses are in the correct locations.
GREY MIXING BOWL = WEEKLY DEPENDING ON VOLUME
Close the Orange sliders and Lift the instant powder dispensing mouths by pulling them up (1).
While holding the grey mixing bowl with one hand use the other hand to push the small black handle at the bottom of the mixing bowl counter clockwise to unlock (3). Pull the grey mixing bowl out towards you to remove. Detach the black tube from the bottom of the mixer (2).
You can split the mixing bowl into 2 pieces to assist in cleaning. Wash clean, dry and re-assemble. It is also worth checking that there are no blockages in the pipe as this can cause problems.
After cleaning the square end of the mixing bowl slides back into the square hole. When in place rotate the black handle to lock it in place. Reconnect the black hose to the bottom of the mixing bowl.
Push the instant powder dispensing mouths back into place and open the orange sliders.
BREWER = WEEKLY DEPENDING ON VOLUME
Clean the Brewer with the brush provided, Remove the brown hose from the end of the brewer (1) Push the click finger to the left and move the brewer approx (2). 10cm towards you.
Brush away the loose coffee with the brush (3), then push the brewer back into place.
EXTERNAL FAN = WEEKLY DEPENDING ON VOLUME
Turn the machine off. Open the fan Grill on the right side of the machine (1) and using the brush just dust inside (2).
Brush away the loose coffee with the brush (3), then push the brewer back into place.
COFFEE BEAN HOPPER = OPTIONAL
Lift the lid to access the coffee bean hopper. You can remove the coffee bean hopper for by sliding it towards you, it automatically closes the bean shute at the bottom when its removed.
You may need to use de-tanning powder to fully remove the coffee stains.
Useful Bravilor Links