Cleaning Your Jura Giga X9c Coffee Machine

Cleaning your Jura Giga coffee machine on a regular basis helps to keep it in tip top
condition. London Coffee Machines animated cleaning guide will guide you through the process step by step.

Jurax9-cleaning
Need help with your Jura Coffee Machine call 0208 111 1122 or email us

Cleaning your Jura Giga X9c Coffee Machine

Need some help? our in-house team of technicians are on hand to solve any problems that you may have with your Jura Giga X9c Coffee Machine, or any of our other other rental or Lease coffee machines.

Our typical response time to fault calls is less than one working day.

Steps to Cleaning your Jura Giga X9c Coffee Machine:

DRIP TRAY  = DAILY DEPENDING ON VOLUME

The drip tray located at the front base of the Coffee machine needs to be emptied and/or cleaned daily.

To remove the drip tray hold the tray and slide the drip tray forward (1), once the tray is clear of the machine remove the drip tray grid (the top just pulls off (2).

CG-JuraX9c-001

COFFEE GROUNDS CONTAINER  = DAILY DEPENDING ON VOLUME

The grout bin collects all the coffee grounds and should be emptied every day depending on volume.

Remove the grout bin once the drip tray has been removed, pull the grout bin upwards and out, then empty and clean.

Make sure the waste bin is completely dry, including the metal contacts on the back of the drip tray and then replace.

CG-JuraX9c-002

RINSING THE COFFEE SYSTEM  = AT ANY TIME

You can perform coffee system rinsing at any time. The display should read ‘Please select product:’

Place a receptacle under the dual spout (1). Then Press the P button on top of the machine. (2).

Press the ‘Rinse the coffee system’ button by the display..

When the Machine is rinsing water flows out of the dual spout.

The rinse stops automatically. ‘Please select product:’ then appears on the display.

CG-JuraX9c-003

RINSING THE MILK SYSTEM  = AT ANY TIME

Depending on the setting in programming mode, the Jura GIGA X9c prompts you to rinse the milk system or automatically performs rinsing following milk preparation.

Proceed as follows to rinse the milk system when prompted to do so.

‘Rinse the milk system.’ is displayed.

Place a receptacle under the dual spout (1). Then Press the P button on top of the machine. (2).

Press the ‘Rinse the milk system’ button by the display..

When the Milk system is being rinsed water flows out of the dual spout.

The rinse stops automatically. ‘Please select product:’ then appears on the display.

CG-JuraX9c-004

CLEANING THE MILK SYSTEM  = ONCE PER DAY IF MILK BASED DRINKS HAVE BEEN USED

In the interests of hygiene, we recommend changing the milk pipe on a regular basis (approx. every 3 months). Replacement pipes are available from London Coffee Machines.

To ensure that the milk system in the dual spout always works properly, you must clean it daily when you have been preparing milk. The GIGA will not prompt you to clean the milk system.

If the wrong cleaning agent is used, the machine could be damaged and/or traces could be left behind in the water. London Coffee Machines supply the Rinza Cappuccino Cleaner

The display should read ‘Please select product:’

Press the P button on top of the machine.

Press the ‘Clean the milk system’ button by the display.

Press the ‘Start’ button.

Press the ‘Start’ button again.

Pour 250 ml of fresh water into a receptacle and add one capful of Rinza Cappuccino Cleaner.

Immerse the milk pipe in the receptacle (1).

Place another receptacle under the dual spout (2).

CG-JuraX9c-005

Press the ‘Next’ button.

The Milk system is being cleaned and water flows out of the dual spout.

Rinse the receptacle thoroughly, fill it with 250 ml of fresh water and immerse the milk pipe in the water.

Empty the other receptacle and place it under the dual spout again.

Press the ‘Next’ button.

The Milk system is being cleaned and the dual spout and the pipe are rinsed with fresh water.

The operation stops automatically. ‘Milk system cleaning complete.’ appears briefly on the display. ‘Please select product:’

DUAL SPOUT = WEEKLY IF MILK CLEANING CYCLE IS PERFORMED DAILY

The dual spout must be dismantled and rinsed daily if milk has been prepared to make sure it functions perfectly and also in the interests of hygiene.

Remove the milk pipe (1) and rinse it thoroughly under running water.

Press the releasing devices (2) and pull the cover of the dual spout up and off.

CG-JuraX9c-006

Carefully pull the bottom part of the milk system down and off.

Remove the milk system from the dual spout, remove the air intake pipe dismantling the milk system into its individual parts.

Rinse all the parts under running water. If there are severely dried-on milk residues, firstly immerse the individual parts in Rinza Cappuccino Cleaner and then rinse them thoroughly.

Reassemble the milk system. Fit the air intake pipe. Fit the assembled individual parts back in the dual spout and press it firmly. Attach the bottom part of the milk system to the part already inserted from below. Fit the cover of the dual spout. It will click into place audibly. Insert the milk pipe into the dual spout.

And close the aroma preservation cover.

CG-JuraX9c-007

PROFESSIONAL STEAM LANCE = RINSED DAILY

The professional steam lance must be dismantled and rinsed daily if milk has been frothed or heated to make sure it functions perfectly and also in the interests of hygiene.

Your GIGA is supplied with two spanners to dismantle the professional steam lance and two brushes to clean the two metal tubes.

Using the spanner provided, unscrew the professional steam lance clockwise (1).

CG-JuraX9c-008

Once removed, Using the two spanners one at the bottom (1) and the other at the top (2), separate the two metal tubes that make up the professional steam lance (3).

Clean both metal tubes thoroughly under running water.

Use the two brushes to clean the inside of the tubes.

Also clean the temperature sensor on the machine.

Reassemble the metal tubes.

Refit the professional steam lance on the machine.

CG-JuraX9c-009

COFFEE BREWER CLEAN  = WHEN PROMPTED BY THE MACHINE OR CAN BE INITIATED MANUALLY EVERY WEEK DEPENDING ON VOLUME

After 220 preparations or 80 switch-on rinses, the GIGA prompts you to clean it. The cleaning program lasts approximately 20 minutes.

Do not interrupt the cleaning program. The quality of cleaning will be impaired if you do so.

JURA cleaning tablets are available from London Coffee Machines. CAUTION – If the wrong cleaning agent is used, the machine could be damaged and/or traces could be left behind in the water.

When prompted to do so by the ‘Clean machine’ message displayed.

Press the P button.

Press the ‘Clean’ button.

Press the ‘Start’ button.

Press the ‘Start’ button again.

Empty the drip tray and coffee grounds container and put them back into the machine (1).

‘Press the Rotary Switch.’

Place a receptacle under the dual spout (2).

CG-JuraX9c-010

Press the Rotary Switch.

The Machine is being cleaned and water flows out of the dual spout.

The operation is interrupted, ‘Add cleaning tablet.’

Open the cover (3) of the filler funnel for ground coffee.

Insert a JURA cleaning tablet into the filler funnel, available from London Coffee Machines.

Close the cover of the filler funnel.

Press the Rotary Switch.

‘The Machine is being cleaned and water flows out of the dual spout.

The operation is interrupted, ‘Empty coffee grounds container.’

Empty the drip tray and coffee grounds container and put them back into the machine.

Cleaning is now complete. Your GIGA is once more ready for use.

DESCALING THE MACHINE  = WHEN PROMPTED BY THE MACHINE

Limescale deposits may form in the water tank. To ensure correct function of the machine, descale the water system when prompted to do so.

The GIGA builds up deposits of limescale over time and automatically prompts you to descale it when necessary. The degree of calcification depends on the hardness of your water.

If the descaling agent comes into contact with the skin or eyes, this can cause irritation. Avoid contact with the skin or eyes. Rinse off the descaling agent with clean water. Should you get any descaling agent in your eye, see a doctor.

If the wrong descaling agent is used, the machine could be damaged and/or traces could be left behind in the water. London Coffee Machines provide this.

If the descaling operation is interrupted, there may be damage to the machine.

Allow the descaling program to run to the end.

If the descaling agent comes into contact with sensitive surfaces (e.g. marble), damage cannot be ruled out. Clean up any splashes immediately.

The descaling program lasts approximately 50 minutes.

JURA descaling tablets are available from London Coffee Machines.

Proceed as follows to perform descaling when prompted to do so with the ‘Decalcify machine.’ message displayed.

Press the P button.

Press the ‘Descale’ button.

Press the ‘Start’ button.

Press the ‘Start’ button again.

Empty the drip tray and coffee grounds container (1) and put them back into the machine.

Remove and empty the water tank, (2) and completely dissolve 6 JURA descaling tablets in a receptacle holding 1000 ml of water. This may take several minutes. Pour the solution into the empty water tank and insert it into the machine.

‘Press the Rotary Switch.’

Place one receptacle under the dual spout and another under the hot-water spout (3).

CG-JuraX9c-011

Press the Rotary Switch.

When the ‘Machine is being descaled.’ water flows repeatedly out of the dual spout and the hot-water spout.

The operation stops automatically. ‘Empty drip tray.’ Appears on the display.

Empty both receptacles.

Empty the drip tray and coffee grounds container and put them back into the machine.

Remove the water tank and rinse it thoroughly. Fill the water tank with fresh, cold water and reinsert the tank.

‘Press the Rotary Switch.’

Place the receptacles back under the dual spout and the hot water spout.

Press the Rotary Switch.

When the ‘Machine is being descaled.’ water flows out of the dual spout and the hot-water spout.

The operation stops automatically. ‘Empty drip tray.’ Appears on the display.

Empty the drip tray and coffee grounds container and put them back into the machine.

Descaling is now complete. Your GIGA is once more ready for use.

If the descaling operation stops unexpectedly, rinse the water tank thoroughly.

BEAN CONTAINER = WEEKLY DEPENDING ON VOLUME

Coffee beans may be covered with a slight oil film, which remains on the walls of the bean containers. These traces may negatively affect the coffee result. For this reason clean the bean containers from time to time.

Switch the machine off with the On/Off button.

Open the service cover on the back of the machine by pressing above the JURA logo.

CG-JuraX9c-012

Push the red sliding catch completely to the rear to close the bean container (1).

Turn the blue locking device outwards (2).

Remove the bean container (3).

CG-JuraX9c-013

Remove the aroma preservation cover.

Empty the bean container.

Clean the bean container with a soft, dry cloth.

Reverse the process and Fit the bean container. Turn the blue locking device inwards. Pull the red sliding catch completely forwards. Refit the service cover and fix it by pressing above the JURA logo. It will click into place audibly. Fill the bean container with coffee beans

Useful Jura Links